DBB Guidebook - Measurement

DBB measurement needs cooperation between measurement program and NC-control. NC program have to be tested with empty mactine tool before measurement. This page includes short movie clips from one measurement session.

You can do DBB measurement by following steps:

1. Start the measurement session with adjusting the DBB device on the calibrator.
2. Calibrate the dbb device by clicking the calibrate button.
3. Run the machine tool to the zero position and center the socket to it's place.
4. Run the machine tool to the measurement position.
5. Start the measurement by clicking the data capturing button.
6. The machine tool starts the CW measurement circle.
7. Change the measurement direction.
8. The machine tool starts the CCW measurement circle.
9. Save the measurement.
10. Close the measuremet window.
11. Analyse the measuremet data.